Spinlock PXR Cam Cleat - Swivel Base 8-10mm PXR0810/SW

PXR0206/SW for single cleat control of jib sheets and dinghy vangs. Preferred by dinghy builders for single line spinnaker hoist systems

• Fast precise control for hand tensioned lines
• Roller action ensures easy release under high load
• Hard anodised alloy cam and base
• Ideal for high performance lines
• Micro size for small diameters
• Three stage release control switch
• Ideal for single line spinnaker hoist systems
• Resists accidental re-cleating
• Lines: 8mm - 10mm (5/16" - 3/8")
• Loads up to 200kg (440lbs)
• Weights: 124g (4.3oz)
• Fasteners: 3 x M5 (3/16") CSK Head (not supplied)

Installation PXR Cam Cleat

Always use drill template provided with packaging, marked on underside of white plinth PXR0206/VP Ensure fastener lengths do not interfere with ropes inside the mast and if using self taping screws, file away sharp ends.
The internal sheave can be moved to accept lines from above and below. Push stainless pin through pivot body and re-insert in required hole. Sheave can also be replaced with Harken 415 Sheave as a ball race alternative.

PXR0206/SW and PXR0810/SW
Remove rear fastener from cleat and lift cleat from swivel base. Access to the swivel base fastener holes can then be gained.

Rope
When using 10mm ( 3/8”) line, ensure end of rope remains same diameter when cut, for easy insertion into cleats.

Servicing
Always wash with fresh water to clear salt build up and remove rope debris.

The following video explains how to use the Spinlock PXR cam cleat: